When you brew with your 9Barista and see water dripping from a small hole on the side of the brass safety ring, the part has been triggered and it is time for a new one.
Sometimes the water comes from the base of the brass ring instead of that small hole. This usually means the brewer was heated without water, so the rubber seal at the valve base got scorched before the ring itself triggered. You still need this part, because the rubber seals and the safety ring come packed together as one set.
THE 9BARISTA SAFETY RING SET INCLUDES
- 2 silicone rings: inner diameter 9.5mm, cross section 1.5mm
- 1 brass ring with an intact tin seal
- Genuine 9Barista UK part
HOW TO FIT THE SAFETY RING ON THE 9BARISTA ESPRESSO MAKER
Swapping the safety ring is simple and takes about 1 minute with the right tool: a 13mm spanner (or an adjustable wrench)
- Step 1: Use the 13mm spanner to loosen the nut above the safety ring, then unscrew the whole valve assembly by hand
- Step 2: Slide the brass ring (with its 2 rubber seals) off the valve assembly. A gentle twist makes it come off more easily
- Step 3: Fit the new brass ring onto the valve assembly with a new silicone seal on each side. The silver tin plug can face either way
- Step 4: Screw the valve assembly back into the boiler by hand, then snug it up with the 13mm spanner. Stop as soon as you feel the brass ring touch the boiler body; a gentle snug is all it needs.
- Step 5: Enjoy the result!

OTHER REPLACEMENT PARTS FOR THE 9BARISTA ESPRESSO MAKER
Video showing every part inside the 9Barista
iCup is proud to bring customers the world’s finest coffee brewing tools.
Tiếng Việt






Reviews
There are no reviews yet.